Difference between revisions of "Benderlink Ethernet Module"
(→Connect to EL Vector Tube Data Centers Using Current Loop Electronics) |
(→Connect to EL Vector Tube Data Centers Using Current Loop Electronics) |
||
Line 23: | Line 23: | ||
<table> | <table> | ||
<tr> | <tr> | ||
− | <td width=200>Wireless | + | <td width=200>Wireless or Wired Benderlink Ethernet Module</td> |
− | + | ||
− | + | ||
− | + | ||
− | + | ||
− | + | ||
− | + | ||
− | + | ||
<td> | <td> | ||
[[image:blink_ethernet_module_vector_benderside_600.jpg|350px]] | [[image:blink_ethernet_module_vector_benderside_600.jpg|350px]] |
Revision as of 17:31, 18 February 2009
Put SERIAL Port Benders on a Wireless or Wired NETWORK at Extended Distances
The module connects any bender or measuring center devices through your Ethernet network to a bender that normally connects using only standard RS-232 signals. It gives your bender or measuring center access to a virtual COM port anywhere on the network in your building. Distance limitations are gone with this protocol. We have WiFi (wireless) and WIRED TCP/IP models.
Connect to EL Vector Tube Data Centers Using Current Loop Electronics
The module can even be equipped with our version of the Eaton Leonard current loop boards (our own model called the CB-EL1) to allow for 100% compatible Eaton Leonard legacy protocol through the network for connection to an EL Vector Tube Data Center
Wireless or Wired Benderlink Ethernet Module |
Examples:
Bender | Description | |
---|---|---|
PINES TS-2000 | Using Benderlink for Pines - Add a module to a Vector Tube Data Center to enable a network connection through a current-loop module directly into the standard Vector bender port. | |
BLM VGP | Using Benderlink for BLM - Add a module to Vector Tube Data Center to enable a network connection through a current-loop module directly into the standard Vector bender port. | |
ROMER to Eaton Leonard | Add a module to any Eaton Leonard bender and make it wireless. | |
CHIYODA | Add this module to a Chiyoda to allow it to communicate over the network from its RS-232 port. | |
KEINS | Add this module to a KEINS to allow it to communicate over the network from its RS-232 port. | |
MiiC | Works with a MiiC to place it on the network |
PDF DataSheets
Download a DataSheet for Benderlink Ethernet Module for Eaton Leonard
|