Difference between revisions of "VTube-LASER"

Revision as of 00:51, 31 October 2012

Connect to a FARO ScanArm, measure tube shapes, and correct benders.

VTube-LASER uses the laser scanner and/or ball probe to:

Example potential clients:

Client 1	A manufacturer of excavators uses VTube to check the hydraulic lines coming in from a vendor.
Client 2	A manufacturer of hydro formed truck frames to adjust benders so that the pipe fits into pre-crush presses.
Client 3	A manufacturer that fabricates tube for the large truck industry. They adjust a bank of benders that are connected directly to VTube-LASER.
Client 4	A manufacturer that fabricates pipe for the oil industry. They adjust very large benders that are connected to VTube-LASER.
Client Example 5	A manufacturer of undersea oil caps that have hundreds of hydraulic lines. They reverse-engineer mock-ups for fabrication.

@@ Line 38: / Line 38: @@
 <tr>
 <td width=100>
-'''Client Example 1'''
+'''Client 1'''
 </td>
 <td width=300>
@@ Line 47: / Line 47: @@
 <tr>
 <td width=100>
-'''Client Example 2'''
+'''Client 2'''
 </td>
 <td width=300>
@@ Line 56: / Line 56: @@
 <tr>
 <td width=100>
-'''Client Example 3'''
+'''Client 3'''
 </td>
 <td width=300>
@@ Line 65: / Line 65: @@
 <tr>
 <td width=100>
-'''Client Example 3'''
+'''Client 4'''
-</td>
-<td width=300>
-A manufacturer that fabricates tube for the large truck industry.  They adjust a bank of benders that are connected directly to VTube-LASER.
-</td>
-</tr>
-<tr>
-<td width=100>
-'''Client Example 4'''
 </td>
 <td width=300>