Difference between revisions of "BendPro"

From ATTWiki
Jump to: navigation, search
 
Line 6: Line 6:
 
BendPro is a popular bender software package used by multiple bender OEMs in the industry.
 
BendPro is a popular bender software package used by multiple bender OEMs in the industry.
  
[[image:Cncpines.jpg]]
+
[[image:bendpro-horn.jpg]]
  
  
== About TS-2000 Measure Center Communications ==
+
== About BendPro Measuring Center Communications ==
  
  
The TS-2000 software allows for communication using the [[Supravision]] [[SVNET]] protocol.  This is a purchased option for the control (not all TS-2000 controls have this option enabled).  Communications are straight-forward, efficient, and very fast.
+
BendPro uses Supravision Network communications as a standard for communications.  Communications are straight-forward, efficient, and very fast.
  
The TS-2000 can also be setup to communicate with:
+
The BendPro can be setup to communicate with:
  
 
* FARO ScanArms running our [[VTube-LASER]] software
 
* FARO ScanArms running our [[VTube-LASER]] software

Revision as of 17:05, 20 March 2013

BendPro-G2.jpg

Contents


BendPro is a popular bender software package used by multiple bender OEMs in the industry.

Bendpro-horn.jpg


About BendPro Measuring Center Communications

BendPro uses Supravision Network communications as a standard for communications. Communications are straight-forward, efficient, and very fast.

The BendPro can be setup to communicate with:


How to Check if Communications is Possible

The Supravision link is sold by PINES as an option. It's important to verify that this option is switched on when discovering if a TS-2000 is ready for communication. The main window contains 16 touchscreen buttons starting with XYZ in the upper left. If the upper-right button reads "Supravision Link", then the option is enabled on that TS-2000 control. If the button says "External Link", then communications is not activated.

What Pines Technology will Need to Activate the Communications Feature

Pines Technology will need to send you a setup program to enable communications. They will ask for this information:

  1. Machine Serial Number
  2. Software Version Number

You can find both of these values in the caption of the TS-2000 software. The software version will be a four digit number like 2.8.6.7 or 3.1.0.2.


Other