Difference between revisions of "Benderlink Ethernet Module"
| Line 1: | Line 1: | ||
| + | <table> | ||
| + | <tr> | ||
| + | <td> | ||
[[image:Blink_ethernet_module_logo.jpg]] | [[image:Blink_ethernet_module_logo.jpg]] | ||
| + | </td> | ||
| + | <td> | ||
| + | [[image:blink_ethernet_module_vector_benderside_600.jpg|350px]] | ||
| + | </td> | ||
| + | </tr> | ||
| + | </table> | ||
| + | |||
[[image:Elpremier_eldataserver.jpg|300px|right|This is a Benderlink wireless device module setup as an Eaton Leonard Data Server Module]] | [[image:Elpremier_eldataserver.jpg|300px|right|This is a Benderlink wireless device module setup as an Eaton Leonard Data Server Module]] | ||
Revision as of 17:23, 18 February 2009
|
|
|
Contents |
SERIAL Port Benders on a NETWORK
The module connects any bender or measuring center devices through your Ethernet network to a bender that normally connects using only standard RS-232 signals. It gives your bender or measuring center access to a virtual COM port anywhere on the network in your building. Distance limitations are gone with this protocol. We have WiFi (wireless) and WIRED TCP/IP models.
The module can even be equipped with Eaton Leonard current loop boards (our own model) to allow for 100% compatible Eaton Leonard legacy protocol through the network!
Any serial or current-loop bender can benefit from this technology.
| Wireless Benderlink Ethernet Module |
|
| Wired Benderlink Ethernet Module |
|
Examples:
| Bender | Description | |
|---|---|---|
| PINES TS-2000 | Using Benderlink for Pines - Add a module to a Vector Tube Data Center to enable a network connection through a current-loop module directly into the standard Vector bender port. | |
| BLM VGP | Using Benderlink for BLM - Add a module to Vector Tube Data Center to enable a network connection through a current-loop module directly into the standard Vector bender port. | |
| ROMER to Eaton Leonard | Add a module to any Eaton Leonard bender and make it wireless. | |
| CHIYODA | Add this module to a Chiyoda to allow it to communicate over the network from its RS-232 port. | |
| KEINS | Add this module to a KEINS to allow it to communicate over the network from its RS-232 port. | |
| MiiC | Works with a MiiC to place it on the network | |
PDF DataSheets
|
|
Download a DataSheet for Benderlink Ethernet Module for Eaton Leonard
|
