Difference between revisions of "VTube-LASER v2.9.14"
(→25pxNEW - REPORT ABSOLUTE CONRAC CORRECTIONS) |
(→25pxNEW - REPORT ABSOLUTE CONRAC CORRECTIONS) |
||
| Line 115: | Line 115: | ||
<td width=300> | <td width=300> | ||
VTube-LASER can now report absolute CONRAC bender corrections using new HTML report template values.<br><br> | VTube-LASER can now report absolute CONRAC bender corrections using new HTML report template values.<br><br> | ||
| − | [[image: | + | [[image:conracbender.png|300px]] |
</td> | </td> | ||
<td> | <td> | ||
| − | [[image: | + | [[image:vtl_2.9.14_conrac_correction_report.png|500px]] |
| + | |||
</td> | </td> | ||
Revision as of 20:42, 28 August 2018
|
Revision 2.9.14Release Date: In development
|
|
NEW - ENTER FRACTION VALUES for FLOATING POINT in PART SETUP, XYZ GRIDS, and LRA GRIDS
|
We discovered a customer that had to manually convert Imperial fractional units from a tube print. So we taught VTube how to accept fraction values in the PART SETUP, XYZ GRIDS, and LRA GRIDS. Acceptable Fraction Forms
Rule Breaker Examples
|
|
NEW - VTUBE IS NOW COMPATIBLE WITH THE NEW FARO 8-AXIS USB DRIVER (6.2.0.26)
|
|
|
FIXED - COULD NOT CLEAR ALL CUT PLANES from the CUT PLANE LIST
|
We discovered that, when you delete the entire list of Cut Planes, VTube-LASER will most likely bring at least one of them back. (They are not cleared permanently.) |
|
NEW - REPORT ABSOLUTE CONRAC CORRECTIONS
|
VTube-LASER can now report absolute CONRAC bender corrections using new HTML report template values. |
|
OTHER CHANGES
Other Pages
- See VTube-LASER Addata ZModem Communications Protocol for more information.
- Back to VTube-LASER
- Back to VTube Software Updates (for LASER Mode)
- See also VTube-STEP
- See also VTube-STEP Revisions
- See VTube-LASER Customer Support Page to download the latest version.
- See the tutorial on DCF - Dual Cylinder Fit
- See the tutorial on DCP - Diameter Cut Planes
- See VTube-LASER Cut Planes
- See How to Measure Tubes Attached to an Evaporator with the DCP Feature
