VTube-LASER v2.9.10

From ATTWiki
Revision as of 11:32, 3 July 2018 by Mcone (Talk | contribs)

Jump to: navigation, search

Vtube-laser logo 1.96.png


Revision 2.9.10

Release Date: July 1, 2018
Current Build: 10


Vtube-laser v2.7 screenshot.png

Contents


Check.jpgNEW - PRESS ACCEPT BUTTON WITHOUT AIMING AT THE PART

VTube-LASER operators know that previous versions of VTube-LASER require that you aim the LASER scanner at the part when you press the accept button at the end of a scan.

  • For the ROMER scanner, this is one of the two side buttons.
  • For the FARO scanner, this is the red button.


We have redesigned the scanning engine so it no longer requires this in-range scanning position.

As of this version, VTube-LASER will watch for and react to the accept button press even if no laser data is incoming.

Vts v2.9.10 ScannerAcceptButton ROMER.png

Vts v2.9.10 ScannerAcceptButton FARO.png




Check.jpgNEW - HERBER Bender Corrections Through a Network

We added and tested HERBER MES file correction support that allows VTube-LASER to correct HERBER benders through a network connection automatically.

HerberSplash.png


Vtl v2.9.10 herber mes bendersetup.png



Check.jpgNEW - HERBER Bender Setup From Solid Model Through a Network

We added the HERBER SOL file protocol that allows VTube-LASER to send NEW data to the HERBER benders through a network connection.

HerberSplash.png

Use this new feature to import solid models into HERBER bender controls.


Vtl v2.9.10 herber sol output.png



Check.jpgFIX- VTUBE-STEP MODE COLLECTION SELECTION ISSUE

(Note: VTube-STEP is included in the VTube-LASER license. It is used for importing model data.)

We found issues with the collected objects in VTube-STEP mode.

  • For example, the selected collected object (see the orange object) would never delete from the screen - even if the operator selected it and pressed delete.

  • This issue could cause index errors in the Collection Features list memory displayed in the grid.

  • The Collection Features Grid would not update automatically after a delete of the models on the screen.

All of these issues have been fixed.

Vvts 2.9.9 collected object selection.png



Check.jpgOTHER CHANGES

  • VTube-LASER will stop a Construct Tube process with ROMER arms if the LASER mode is active. It will also issue a warning to turn the LASER off.

  • The laser stripe data is now displayed on the screen with lines between the points. This feature makes the stripes much easier to see on the screen.





Other Pages