VTube-LASER v2.9.10

From ATTWiki
Revision as of 23:49, 2 July 2018 by Mcone (Talk | contribs)

Jump to: navigation, search

Vtube-laser logo 1.96.png


Revision 2.9.10

Release Date: July 1, 2018
Current Build: 10


Vtube-laser v2.7 screenshot.png

Contents


Check.jpgNEW - HERBER Bender Corrections Through a Network

We added and tested HERBER MES file correction support that allows VTube-LASER to correct HERBER benders through a network connection automatically.

HerberSplash.png


Vtl v2.9.10 herber mes bendersetup.png



Check.jpgNEW - HERBER Bender Setup From Solid Model Through a Network

We added the HERBER SOL file protocol that allows VTube-LASER to send NEW data to the HERBER benders through a network connection.

HerberSplash.png

Use this new feature to import solid models into HERBER bender controls.


Vtl v2.9.10 herber sol output.png



Check.jpgNEW - PRESS ACCEPT BUTTON WITHOUT AIMING AT THE PART

VTube-LASER operators know that previous versions of VTube-LASER require that you aim the LASER scanner at the part when you press the accept button at the end of a scan.

  • For the ROMER scanner, this is one of the two side buttons.
  • For the FARO scanner, this is the red button.)


    <We have redesigned the scanning engine so it no longer requires this in-range arm.

    As of this version, VTube-LASER removes that requirement. VTube will watch for and react to the accept button press even if no laser data is incoming.

Vts v2.9.10 ScannerAcceptButton ROMER.png

Vts v2.9.10 ScannerAcceptButton FARO.png



Check.jpgFIX- CONSTRUCT TUBE FEATURE WORKS AGAIN

A customer discovered that the Construct Tube feature was not working in the previous version due to changes in the measuring code logic.

We fixed the broken code in this version.

Vtube-laer v2.9.9 constructfeature.png



Check.jpgFIX- VTUBE-STEP MODE COLLECTION SELECTION ISSUE

(Note: VTube-STEP is included in the VTube-LASER license. It is used for importing model data.)

We found issues with the collected objects in VTube-STEP mode.

  • For example, the selected collected object (see the orange object) would never delete from the screen - even if the operator selected it and pressed delete.

  • This issue could cause index errors in the Collection Features list memory displayed in the grid.

  • The Collection Features Grid would not update automatically after a delete of the models on the screen.

All of these issues have been fixed.

Vvts 2.9.9 collected object selection.png



Check.jpgOTHER CHANGES

  • VTube-LASER will stop a Construct Tube process with ROMER arms if the LASER mode is active. It will also issue a warning to turn the LASER off.

  • The laser stripe data is now displayed on the screen with lines between the points. This feature makes the stripes much easier to see on the screen.





Other Pages