Difference between revisions of "VTube-LASER v1.75.1"

From ATTWiki
Jump to: navigation, search
(25px NEW: "Pull Arm From Resting Position" Message)
(25px NEW: Separate Cylinder Fit Tolerances for LONG and SHORT Cylinders)
Line 46: Line 46:
  
  
 
 
===[[image:Check.jpg|25px]] NEW: Separate Cylinder Fit Tolerances for LONG and SHORT Cylinders===
 
 
<table cellpadding=10>
 
<tr valign=top>
 
<td width=300>
 
VTube now has a second set of tolerances for shorter straights.  This allows for looser tolerances on shorter straights without producing an error message.
 
<br><br>
 
</td>
 
<td width=300>
 
[[image:LongAndShortCylinderFitSetup.jpg|300px]]
 
</td>
 
</tr>
 
</table>
 
  
  

Revision as of 12:11, 2 February 2012

Vtube-laser logo.jpg

Revision 1.75.1

Back to VTube-LASER
Back to VTube-STEP

Vtube-laser 1 73.jpg


Check.jpg ENHANCEMENT: Added Page Numbers to Reports in Print Preview

VTube now shows the date, time, and page numbers at the bottom of print preview reports.

VTube-LASER Print Preview PageNumbers.jpg

Check.jpg FIX: Previous Move During Remeasure

There were circumstances where VTube would backup too many steps during a remeasure. This has been repaired.






Check.jpg Other Changes

A new tolerance is added for surface point diameter check.


The current arm firmware is now read and used by VTube to determine how to handle the arm during Scanner Control changes.

ArmFirmware.jpg

For high-precision end scans, new end-scan techniques are recommended in the VTube-LASER manual.

EndScanAfterTarget.jpg

The VTube SVNET protocol now knows how to handle leftover communications files if they are present.

VTube can now save Supravision data to multiple file extension types: $$$, SV, or S2B

VTube-LASER now takes in scanned points faster than before.
VTube-LASER installation now allows for installing either MM or INCH default setups.
Default setups were fine-tuned in VTube-LASER so that VTube works faster.

Other Pages