Previous versions of VTube always assumed that operators meant to connect to a FARO arm. This causes the interface to pause repeatedly while it tries to reconnect to the arm that is not present.
Now VTube will assume that operators should control when to connect to the arm in the Measure Setup pane.
The button is in the new tab menu called "Arm." When the arm is not connected, the button will read Connect to the Arm. When the arm is connected to VTube, then the button will read Disconnect from the Arm.
The disconnect will let operators disconnect from arms to move arms away or switch arms.
Just as in previous versions, it is not necessary to disconnect the arm when exiting the software.
|
|