Difference between revisions of "End-Scan Using End Targets"
(→How the End-Scan technique works) |
(→How the End-Scan technique works) |
||
| Line 29: | Line 29: | ||
<td width=300> | <td width=300> | ||
<br><br> | <br><br> | ||
| − | * The image at the right shows the end of a copper tube with a sharp burr and a | + | * The image at the right shows the end of a copper tube with a sharp burr and a highly reflective end-wall. It is very difficult to aim the laser at this end wall and ensure no outliers at the same time.<br><br> |
*The solution is to use white targets on the end of the tubes. The example here shows white poly labels that measure at 0.004" thick and provide an excellent flat target for the laser. | *The solution is to use white targets on the end of the tubes. The example here shows white poly labels that measure at 0.004" thick and provide an excellent flat target for the laser. | ||
</td> | </td> | ||
Revision as of 21:59, 27 January 2012
|
|
|
Why the End-Scan technique is important
The quick End-Scan Using the Scissor Motion technique is not always precisely repeatable if you use any of the AUTO exposure settings to set the LASER exposure in real-time. The reason is that as he laser drops off the end of the tube, the automatic exposure feature impacts which of the points are kept where the tube drops off (at the end).
The solution to this issue is to use the End-Scan Using the End Wall technique - which works well for tubes that have end-walls that are easy to aim at - AND end-walls that are not highly reflective with deformations like burrs.
For tubes that don't qualify for either of the above techniques, we recommend end targets for ultra-precise measurements.
How the End-Scan technique works
|
|
|
|
|
|
