Difference between revisions of "CNC Bender v12.12"

From ATTWiki
Jump to: navigation, search
(25px ENHANCED: Part Filename Mode in Keyboard)
(25px ENHANCED: Part Filename Mode in Keyboard)
Line 72: Line 72:
  
  
==[[image:Check.jpg|25px]] ENHANCED: Part Filename Mode in Keyboard==
+
==[[image:Check.jpg|25px]] NEW: [Tube Support Override] Command==
  
 
<table>
 
<table>
Line 80: Line 80:
 
The new [Tube Support Override] processlist command is added to this version.<br><br>
 
The new [Tube Support Override] processlist command is added to this version.<br><br>
  
This command can be set to ENABLE or DISABLE like this:
+
This command can be set to ENABLE or DISABLE in order to override CNC Processor from handling the tube support automatically.
  
 +
An example use is to use it in the Home processlist to customize the tube support during homing.
 +
</td>
 +
 +
<td>
 
<pre>
 
<pre>
  
Line 89: Line 93:
  
 
</pre>
 
</pre>
 
Use this command to override processor handling the tube support when in the Home processlist.
 
</td>
 
 
<td>
 
  
 
</td>
 
</td>

Revision as of 21:36, 20 August 2014

v12.12 - August 25, 2014

Cncv12procontrol withteachmode.jpg


Check.jpg ENHANCED: CNC Processor - Machine Lube Feature

CNC Processor can control machine lube at a lower level. This enables machine lube to work even when other motion is occurring. These are the changes for machine lube in this version:

  • Depending on the style of switch that indicates the lube is complete, lube complete could be configured to either HIGH or LOW. So now this feature can allow a machine lube switch to be active when it is LOW.

  • In this version , when the feature is active, and the E-Stop is pressed, the lube is immediately stopped.

  • New messages for the machine lube are posted in the Processor log in the CNC Bender user interface.

Cncbender v12.12 machinelube screenshot.png



Check.jpg ENHANCED: Part Filename Mode in Keyboard

Previous versions of CNC Bender would allow characters in part names that made the part name illegal or caused problems to CNC Bender.

  • This issue has been resolved in this version with a keyboard that will make the disallowed character buttons to disappear when in the filename mode.

  • When these characters are pressed on the physical keyboard when this mode is active, then the key presses will be ignored.



The characters filter out are:

  • < (less than)
  • > (greater than)
  •  : (colon)
  • " (double quote)
  • / (forward slash)
  • \ (backslash)
  • | (vertical bar or pipe)
  •  ? (question mark)
  • * (asterisk)
  • = (equals sign)



Cncbender 12.12 keyboard filename mode.png




Check.jpg NEW: [Tube Support Override] Command

The new [Tube Support Override] processlist command is added to this version.

This command can be set to ENABLE or DISABLE in order to override CNC Processor from handling the tube support automatically.

An example use is to use it in the Home processlist to customize the tube support during homing.


[Tube Support Override] enable

[Tube Support Override] disable



Check.jpg Other Changes

  • The Cycle Hold and Master Power ON buttons can now be defined so that LOW means activated.



Other Pages