CNC Bender v12-20100316

Type of Upgrade: Feature Upgrade New Bend option added

NEW - Feed Speed Percentage Adjustment for Feed Bend Mode

This new bend option allows you to fine-tune the calculated feed speed during Feed Bending. Value Type The value is entered as a floating point percentage. + or - The value can be positive or negative. Impact of Negative Values Negative values slow the calculated speed of the Feed axis. Example + A value of +100 would double the speed of the Feed axis during draw bending. Example - A value of -100 would set the speed at 0 for the Feed axis during draw bending.

This is an example of a -10% change in the processlist:

Speed calculated at 100% (see vel0) Same speed calculated at 90%(see vel0)

Other Pages

• Back to CNC Bender
• Back to CNC Bender Software Updates
• See CNC Bender General Information
• See Teach Mode
• See Custom Commands