CNC Bender v12-20100316

Type of Upgrade: Feature Upgrade New Bend option added

NEW - Feed Speed Percentage Adjustment for Feed Bend Mode

This new bend option allows you to fine-tune the calculated feed speed during Feed Bending.
Value Type:	The value is entered as a floating point percentage.
+ or -:	The value can be positive or negative.
Impact of Negative Values:	Negative values slow the calculated speed of the Feed axis when pushing behind a draw bend
Example +:	A value of +100 would double the speed of the Feed axis during draw bending.
Example -:	A value of -100 would set the speed at 0 for the Feed axis during draw bending.
The table at the right shows an example of a -10% change in the processlist:	See vel0 calculated at 100%: See the same velocity with the option set to -10 (which represents 90% speed):

Other Pages

• Back to CNC Bender
• Back to CNC Bender Software Updates
• See CNC Bender General Information
• See Teach Mode
• See Custom Commands