CNC Bender v12-20100316

From ATTWiki
Revision as of 12:58, 16 March 2010 by Mcone (Talk | contribs)

Jump to: navigation, search

Cncv12procontrol withteachmode.jpg

Type of Upgrade: Feature Upgrade

New Bend option added

V12mainmenu.jpg

Contents


Check.jpg NEW - Feed Speed Percentage Adjustment for Feed Bend Mode

This new bend option allows you to fine-tune the calculated feed speed during Feed Bending.

Value TypeThe value is entered as a floating point percentage.
+ or -The value can be positive or negative floating point number.
Negative ValuesNegative values slow the calculated speed of the Feed axis.
Example +A value of +100 would double the speed of the Feed axis during draw bending.
Example -A value of -100 would set the speed at 0 for the Feed axis during draw bending.

FeedSpeedPercentageAdjustmentOption.jpg

For example "-10" means negative 10 percent.

Speed calculated at 100% (see vel0)
Processlist feedspeedadjustbefore.jpg

Same speed calculated at 90%(see vel0)
Processlist feedspeedadjustafter.jpg



Other Pages