Difference between revisions of "CNC Bender v12-20100316"

From ATTWiki
Jump to: navigation, search
(25px NEW - Feed Speed Percentage Adjustment for Feed Bend Mode)
(25px NEW - Feed Speed Percentage Adjustment for Feed Bend Mode)
Line 39: Line 39:
 
<tr><td>'''Value Type:'''</td><td>The value is entered as a floating point percentage.</td></tr>
 
<tr><td>'''Value Type:'''</td><td>The value is entered as a floating point percentage.</td></tr>
 
<tr><td>'''+ or -:'''</td><td>The value can be positive or negative.</td></tr>
 
<tr><td>'''+ or -:'''</td><td>The value can be positive or negative.</td></tr>
<tr><td>'''Impact of Negative Values:'''</td><td>Negative values slow the calculated speed of the Feed axis.</td></tr>
+
<tr><td>'''Impact of Negative Values:'''</td><td>Negative values slow the calculated speed of the Feed axis when pushing behind a draw bend</td></tr>
 
<tr><td>'''Example +:'''</td><td>A value of +100 would double the speed of the Feed axis during draw bending.</td></tr>
 
<tr><td>'''Example +:'''</td><td>A value of +100 would double the speed of the Feed axis during draw bending.</td></tr>
 
<tr><td>'''Example -:'''</td><td>A value of -100 would set the speed at 0 for the Feed axis during draw bending.</td></tr>
 
<tr><td>'''Example -:'''</td><td>A value of -100 would set the speed at 0 for the Feed axis during draw bending.</td></tr>

Revision as of 13:07, 16 March 2010

Cncv12procontrol withteachmode.jpg

Type of Upgrade: Feature Upgrade

New Bend option added

V12mainmenu.jpg

Contents


Check.jpg NEW - Feed Speed Percentage Adjustment for Feed Bend Mode

This new bend option allows you to fine-tune the calculated feed speed during Feed Bending.

FeedSpeedPercentageAdjustmentOption.jpg

Value Type:The value is entered as a floating point percentage.
+ or -:The value can be positive or negative.
Impact of Negative Values:Negative values slow the calculated speed of the Feed axis when pushing behind a draw bend
Example +:A value of +100 would double the speed of the Feed axis during draw bending.
Example -:A value of -100 would set the speed at 0 for the Feed axis during draw bending.



The table at the right shows an example of a -10% change in the processlist:



See vel0 calculated at 100%:
Processlist feedspeedadjustbefore.jpg

See the same velocity with the option set to -10 (which represents 90% speed):
Processlist feedspeedadjustafter.jpg



Other Pages