Difference between revisions of "CNC Bender v11-20091007"
From ATTWiki
| Line 18: | Line 18: | ||
*When CNC Bender is in the Low Level menu. | *When CNC Bender is in the Low Level menu. | ||
*When the CNC Bender numeric keypad is active. | *When the CNC Bender numeric keypad is active. | ||
| + | |||
| + | <br><br> | ||
=Other Pages= | =Other Pages= | ||
Revision as of 13:01, 7 October 2009
NEW - Low Level - Rotate Reset Mode
The Rotate Reset Mode controls if the rotate axis is reset to zero between every bend by default. If you intend to use Absolute Pre-Rotate Enable with multiple parts in the Runlist, and the axis should never reset itself except when homing, then the Rotate Reset mode can be set to DISABLE.
The default mode is ENABLED.
NEW - Spacebar Filter Mode
Pressing the spacebar in Windows causes any focused button to "click." This can cause manual jog moves with the press of the spacebar. Some users prefer that this Windows feature be disabled for better safety.
This version of CNC Bender has a new Spacebar Filter Mode in Low Level that, by default, will prevent the "clicking" of any buttons or controls in CNC Bender software. The exceptions are:
- When CNC Bender is in the Low Level menu.
- When the CNC Bender numeric keypad is active.
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender General Information
- See Absolute Rotate
- See Absolute Rotate Offset Position
- See Final Feed Clearance
- See Mandrel Retract
- See Mandrel Retract Part Release
