Difference between revisions of "CNC Bender v11-20090928"

From ATTWiki
Jump to: navigation, search
(Other Pages)
 
(4 intermediate revisions by one user not shown)
Line 4: Line 4:
 
__NOTOC__
 
__NOTOC__
  
===[[image:Check.jpg|25px]] NEW - Simultaneous Absolute Rotate DURING Final Feed Clearance ===
+
===[[image:Check.jpg|25px]] NEW - Simultaneous Absolute Rotate DURING Final Feed Clearance for Faster Cycles ===
  
 
This version of CNC Bender uses secondary process lists to set the [[Absolute Rotate]] position in the chuck while the [[Final Feed Clearance]] move is in action.<br><br>
 
This version of CNC Bender uses secondary process lists to set the [[Absolute Rotate]] position in the chuck while the [[Final Feed Clearance]] move is in action.<br><br>
Line 19: Line 19:
  
 
<tr>
 
<tr>
<td width=200>
+
<td width=200 cellpadding=10>
 
In-Bend Mandrel Retract Command
 
In-Bend Mandrel Retract Command
 
</td>
 
</td>
Line 44: Line 44:
 
*See [[CNC Bender General Information]]
 
*See [[CNC Bender General Information]]
 
*See [[Absolute Rotate]]
 
*See [[Absolute Rotate]]
 +
*See [[Absolute Rotate Offset Position]]
 +
*See [[Final Feed Clearance]]
 
*See [[Mandrel Retract]]
 
*See [[Mandrel Retract]]
 
*See [[Mandrel Retract Part Release]]
 
*See [[Mandrel Retract Part Release]]

Latest revision as of 06:15, 29 September 2009

Cncbender logo pushbending.png

Operatorstation model.jpg


Check.jpg NEW - Simultaneous Absolute Rotate DURING Final Feed Clearance for Faster Cycles

This version of CNC Bender uses secondary process lists to set the Absolute Rotate position in the chuck while the Final Feed Clearance move is in action.

This can trim seconds off the part cycle - especially in cases where the Absolute Rotate Offset Position is far from zero degrees.

Check.jpg NEW - Separate Part Release Mandrel Retract Command for Faster Cycles

A Mandrel Retract Part Release command is added to separate it from all other Mandrel Retraction commands.

Since this feature allows CNC Bender to treat the last mandrel retraction separately from the in-bend mandrel retractions, you can increase a pause in the command after the final mandrel retraction while decreasing or eliminating the pauses or prox. switch examinations in the in-bend mandrel retractions - thus shaving cycle time.

In-Bend Mandrel Retract Command

MandrelRetract

New Part Release Mandrel Retract Command

MandrelRetract_PartRelease

Other Pages