Difference between revisions of "CNC Bender v11-20090928"

From ATTWiki
Jump to: navigation, search
(25px NEW - Separate Part Release Mandrel Retract Command for Faster Cycles)
(25px NEW - Separate Part Release Mandrel Retract Command for Faster Cycles)
Line 12: Line 12:
 
===[[image:Check.jpg|25px]] NEW - Separate Part Release Mandrel Retract Command for Faster Cycles ===
 
===[[image:Check.jpg|25px]] NEW - Separate Part Release Mandrel Retract Command for Faster Cycles ===
  
Now the final [[Mandrel Retract]] command is unique from all other [[Mandrel Retract]] commands.  This allows for treating the final [[Mandrel Retract]] with a special timer or to watch a prox. switch in order to ensure that the mandrel is completely home before fully retracted.<br><br>
+
Now the final [[Mandrel Retract]] command is unique from all other [[Mandrel Retract]] commands.<br><br>
  
 
Since this feature allows CNC Bender to treat the in-bend mandrel retractions separately from the last mandrel retraction, you can increase a pause after the final mandrel retraction while decreasing or eliminating the pauses or prox switch examinations in the in-bend mandrel retractions - thus shaving cycle time.
 
Since this feature allows CNC Bender to treat the in-bend mandrel retractions separately from the last mandrel retraction, you can increase a pause after the final mandrel retraction while decreasing or eliminating the pauses or prox switch examinations in the in-bend mandrel retractions - thus shaving cycle time.

Revision as of 06:04, 29 September 2009

Cncbender logo pushbending.png

Operatorstation model.jpg


Check.jpg NEW - Simultaneous Absolute Rotate DURING Final Feed Clearance

This version of CNC Bender uses secondary process lists to set the Absolute Rotate position in the chuck while the Final Feed Clearance move is in action.

This can trim seconds off the part cycle - especially in cases where the Absolute Rotate Offset Position is far from zero degrees.

Check.jpg NEW - Separate Part Release Mandrel Retract Command for Faster Cycles

Now the final Mandrel Retract command is unique from all other Mandrel Retract commands.

Since this feature allows CNC Bender to treat the in-bend mandrel retractions separately from the last mandrel retraction, you can increase a pause after the final mandrel retraction while decreasing or eliminating the pauses or prox switch examinations in the in-bend mandrel retractions - thus shaving cycle time.

In-Bend Mandrel Retract Command

MandrelRetract

New Part Release Mandrel Retract Command

MandrelRetract_PartRelease

Other Pages