Difference between revisions of "CNC Bender v11-20090928"
| Line 4: | Line 4: | ||
__NOTOC__ | __NOTOC__ | ||
| − | ===[[image:Check.jpg|25px]] NEW - Absolute Rotate | + | ===[[image:Check.jpg|25px]] NEW - Simultaneous Absolute Rotate DURING Final Feed Clearance === |
This version of CNC Bender uses secondary process lists to set the [[Absolute Rotate]] position in the chuck while the [[Final Feed Clearance]] move is in action.<br><br> | This version of CNC Bender uses secondary process lists to set the [[Absolute Rotate]] position in the chuck while the [[Final Feed Clearance]] move is in action.<br><br> | ||
Revision as of 06:01, 29 September 2009
NEW - Simultaneous Absolute Rotate DURING Final Feed Clearance
This version of CNC Bender uses secondary process lists to set the Absolute Rotate position in the chuck while the Final Feed Clearance move is in action.
This can trim seconds off the part cycle - especially in cases where the Absolute Rotate Offset Position is far from zero degrees.
NEW - Separate Part Release Mandrel Retract Command
Now the final Mandrel Retract command is unique from all other Mandrel Retract commands. This allows for treating the final Mandrel Retract with a special timer or to watch a prox. switch in order to ensure that the mandrel is completely home before fully retracted. With this feature you can remove the prox input check from in-bend mandrel retractions to make the cycle move more quickly.
|
In-Bend Mandrel Retract Command |
MandrelRetract |
|
New Part Release Mandrel Retract Command |
MandrelRetract_PartRelease |
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender General Information
