CNC Bender v11-20090826

From ATTWiki
Revision as of 20:15, 26 August 2009 by Mcone (Talk | contribs)

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

Cncbender logo pushbending.png

Operatorstation model.jpg


Check.jpg NEW - END CYCLE Mode Can Be Controlled By External Processes

Since CNC Bender can run scores of processes simultaneously, the END CYCLE mode is "tail-out" feature that allows all the processes to pause at the end of running the cycle in order to allow an orderly shut-down of all mechanisms controlled by CNC Bender. This would especially apply to hoppers, loaders of all types, unloaders, and other secondary processes that run around the machine.

CNC Bender used to control the End Cycle mode from within the CNC Bender interface only in the control mode bar (on the right side of the screen).

Now CNC Bender monitors a programmable CIO input (in Low Level) that can also change the End Cycle mode from a processlist or an external computer. The process simply changes the point state being monitored, and the mode button in the main CNC Bender screen set itself to the state automatically.

Cncbender three outputcionames.jpg

Cncbender three controlmodes.jpg

Other Pages