Difference between revisions of "CNCProcessor.cfg"

Revision as of 01:15, 13 July 2007

What is It?

The CNCProcessor.cfg file exists in the c:\cnc\config folder. It contains setup information for the CNC Processor.

Sections

Each of the sections in the CNCProcessor.cfg is set apart with an axis section label like this:

[Intervals]

Properties

Example properties for an axis:

[Intervals]

Machine Lube Duration= 5000
Lube Machine At Bend Count= 1000

[CIO]
CIO Name Of Input Clamp Die Close=Input_ClampIsClosed_Begin
CIO Name Of Input Pressure Die Home=Input_PressureDieIsHome_End
CIO Name Of Input Pressure Die Close=Input_PressureDieIsClosed_Begin
CIO Name Of Input Carriage Cross Slide Advance=Input_CarriageCrossSlideIsAdvanced_End
CIO Name Of Input Release  Button= Input_Release_Button_End
CIO Name Of Output Release Illuminate= Output_Release_Illuminate
CIO Name Of Boost Bottom Advance= Output_BoostBottom_Advance
CIO Name Of Boost Top Advance= Output_BoostTop_Advance
CIO Name Of Bend Positive= MOVE_BEND_POS_RELATIVE
CIO Name Of Output Machine Lube=Output_MachineLube_Repeat


[SOUND]
INIT=cncbender_initialized.wav
AE=all_axes_enabled.wav
AD=all_axes_disabled.wav
WRE=warning_range_error_encountered.wav
CH=cycle_hold.wav
CS=cycle_start.wav
MM=manual_mode.wav
SM=step_mode.wav
AM=auto_mode.wav
SMMF=switch_to_manual_mode_first.wav

[PRIORITY]
Master Loop Priority=10000

Note that remarks may be added to the file with lines preceded by double forward slashes.

// How long does the machine loop output enable?

Properties Definition

Read about individual properties:
Lube Machine At Part Count
Lube Machine At Bend Count

--Mcone 23:18, 19 July 2006 (EDT)