Difference between revisions of "Benderlink for SolidWorks"

From ATTWiki
Jump to: navigation, search
Line 13: Line 13:
 
<li> - Send new nominal data to benders that support [[SVNET]] protocol.</li>
 
<li> - Send new nominal data to benders that support [[SVNET]] protocol.</li>
 
<li> - Make and send correction data to benders that support the [[SVNET]] protocol.</li>
 
<li> - Make and send correction data to benders that support the [[SVNET]] protocol.</li>
<ol>
 
 
<li>Reverse-engineer tube shapes</li>
 
<li>Reverse-engineer tube shapes</li>
 
<li>Correct bender data</li>
 
<li>Correct bender data</li>
</ol>
 
 
</ol>
 
</ol>
  

Revision as of 22:28, 28 July 2006

Benderlink for Solid Works software is designed to convert from Solid Works to bender data then to connect Solid Works workstations to SVNET-based benders.

If a measuring center arm is setup to sketch a 3D centerline of a measured tube shape, then Benderlink will help you reverse-engineer tube shapes, and assist in correcting the bender's data.


Features

The main features of this software:

  1. - Read tube data from Solid Works
  2. - Convert the tube data to bender data
  3. - Save / Recall the bender data
  4. - Send new nominal data to benders that support SVNET protocol.
  5. - Make and send correction data to benders that support the SVNET protocol.
  6. Reverse-engineer tube shapes
  7. Correct bender data


http://advancedtubular.com/blink_sw/help_html/clip0003.jpg


The correction feature is peformed by measuring a tube with ROMER / FARO arm, using this data to create a tube centerline in Solid Works, then allow Benderlink to compare this inspected data with the MASTER data.


[1] Read the online help


--Mcone 13:37, 28 July 2006 (EDT)