Difference between revisions of "Benderlink for Pines"

From ATTWiki
Jump to: navigation, search
(About)
Line 23: Line 23:
 
|}
 
|}
  
=Versions=
+
=Version 2.0 - Plug-And-Play Compatible with Vector Laservision=
 
+
 
+
==Version 2.0 - Plug-And-Play Compatible with Vector Laservision==
+
  
 
{| border="0" cellpadding="5" cellspacing="0" align="none" width=700
 
{| border="0" cellpadding="5" cellspacing="0" align="none" width=700
Line 37: Line 34:
 
|}
 
|}
  
==Version 1.0 - (Obsolete)==
+
=Version 1.0 (Obsolete)=
  
 
{| border="0" cellpadding="5" cellspacing="0" align="none" width=700
 
{| border="0" cellpadding="5" cellspacing="0" align="none" width=700

Revision as of 01:18, 1 May 2008

Light arrows.jpg

Blink pines logo.jpg


Contents

About

Benderlink for Pines is software that connects PINES TS-2000 controls with Eaton Leonard Vector Laservision measuring centers.

It essentially makes a TS-2000 control appear to be an Eaton Leonard PREMIER control to a Vector Laservision measuring center.

Blinkpines v2 mainscreen.jpg

TS-2000 Control to Vector 1 Laservision

Ts-2000.jpg The software installs directly on the operator station of the Pines TS-2000 controls. It is designed to interact directly with the control. The designer of the TS-2000 included a "Laservision" button that loads and calls to Benderlink for Pines.

The protocol used is the Velog/El-2000/Premier protocol - so the software is compatible with Eaton Leonard Vector Laservision out of the box.

EL Laservision Tube Data Center.jpg

Version 2.0 - Plug-And-Play Compatible with Vector Laservision

Version 2 is designed to communicate using the standard Eaton Leonard Velog, EL-2000, and Premier protocol. This protocol is available on every Eaton Leonard measuring center.


This version makes any PINES bender answer as a Velog, EL-2000, or Premier control.

Both STANDARD and EXTENDED protocols are handled. The Extended protocol is intended for multiple radius benders.

Blinkpines v2 mainscreen.jpg

Version 1.0 (Obsolete)

Version 1 of Benderlink for Pines communicated with Laservisions using the ATT protocol. The ATT protocol was a special protocol that required customers to purchase and install an upgrade to the Vector Laservision. Eaton Leonard referred to this as a "Competitive Bender Interface" because it was designed to grant competitors the right to use the measuring center through license charges.


This CBI kit was costly and time-consuming for the customer. Version 2 of our software addressed this issue.

Blinkpines v1 mainscreen.jpg



LASERVISION.jpg
PINES bender.jpg

Other Pages

Back to the Benderlink Page