Difference between revisions of "Benderlink Ethernet Module for PINES to Vector"

From ATTWiki
Jump to: navigation, search
(Example Installation)
Line 32: Line 32:
 
<br>
 
<br>
 
[[image:Blink_module_vector_test1.jpg|300px]]
 
[[image:Blink_module_vector_test1.jpg|300px]]
 +
 +
[[image:Blink_module_vector_test2.jpg|400px]]
  
 
==Purchasing==
 
==Purchasing==

Revision as of 13:13, 2 May 2008

Blinklines2vector pdfimage.jpg


This is a single port Benderlink Ethernet Module that works with Benderlink for Pines to connect a TS-2000 (Pines) control to an Eaton Leonard Vector 1 measuring center.

This device is 100% Eaton Leonard Vector 1 Compatible. Any standard Vector 1 bender port can connect with this module. It is placed near the Vector 1 Laservision measuring center.

About the Connections

  • One RJ-45 port - This connects to the Ethernet.
  • One Military Connector - This connector follows the legacy Eaton Leonard style connection. You can connect standard communications cable with circular connectors at either end.
  • One Power Port - Any voltage from 90 to 264 VAC accepted.



Inside the Module

This is an image of the inside of the module.

  • The Current Loop board is in the upper left corner.

  • The Ethernet Serial Device Server is the black box on the right.

  • The power supply is on the lower left.

Blink module vector test3.jpg

Example Installation


This is an image of the box installed on a test bench computer running Benderlink for Eaton Leonard, which simulates Vector 1 Laservision communications.

Blink module vector test1.jpg

Blink module vector test2.jpg

Purchasing


This item can be purchased from our Online Store

Other Pages