CNC Bender v12.12

v12.12 - August 25, 2014 Back to CNC Bender Software Updates See CNC Bender Customer Service Page for an update.

ENHANCED: Machine Lube Feature

Depending on the style of switch, lube complete could be configured to either HIGH or LOW. So now this feature can allow a machine lube switch to be active when it is LOW. In this version , when the feature is active, and the E-Stop is pressed, the lube is immediately stopped. New messages for the machine lube are posted in the Processor log in the CNC Bender user interface.

ENHANCED: No Longer Clear Tool Data Page with TubeShape Clear

Previous versions of CNC Bender would clear the Tool page when the Tube Shape page was cleared. This creates a problem in workflow, because the tool data is setup before the part is setup. Clearing the TubeShape page should never clear the tool page. This issue has been resolved in this version.

FIX: Custom Command Editor

The Custom Commands menu and Custom Command Editor would sometimes show an error when clearing the menu then re-entering the Editor. This problem has been resolved in this version.

ENHANCED: CNC Program Loader Allows for Adjustable CNC Executable Location

The location of the CNC Bender executable files can change depending on the application. The Program Loader can now run the CNC Bender program from any location - not just the standard "C:\CNC" folder location.

Other Changes

Removed the second scroll bar on the right side of the File Load menu since it was redundant.

Other Pages

• Back to CNC Bender
• Back to CNC Bender Software Updates
• See CNC Bender Customer Service Page for an update.
• See CNC Bender General Information
• See Teach Mode
• See Custom Commands