Difference between revisions of "VTube-LASER v2.9.12"
(→25pxNEW LRA POPUP MENU SPLITS ONE BEND INTO TWO) |
(→25pxNEW LRA POPUP MENU SPLITS ONE BEND INTO TWO) |
||
Line 34: | Line 34: | ||
This is useful for when a very high bend angle throws its intersection point far from the tube and then creates unreliably high swings in the tangent deviation and bender correction data.<br><br> | This is useful for when a very high bend angle throws its intersection point far from the tube and then creates unreliably high swings in the tangent deviation and bender correction data.<br><br> | ||
Use this new feature with the SPLIT BEND measuring feature.<br><br> | Use this new feature with the SPLIT BEND measuring feature.<br><br> | ||
+ | </td> | ||
+ | |||
+ | <td> | ||
+ | [[image:vtl_v2.9.12_split_bend_into_two_adjacent.png|400px]] | ||
+ | </td> | ||
+ | |||
+ | <td> | ||
+ | [[image:Split Bend Angle Into Two Bends - Slide 2.png|400px]] | ||
+ | </td> | ||
+ | |||
+ | </tr> | ||
+ | |||
+ | <tr valign=top> | ||
− | < | + | <td width=300> |
===Follow these steps to use with Split Bend Measuring=== | ===Follow these steps to use with Split Bend Measuring=== | ||
Line 55: | Line 68: | ||
</tr> | </tr> | ||
+ | |||
</table> | </table> |
Revision as of 23:58, 10 August 2018
Revision 2.9.12Release Date: August 13, 2018
|
Contents |
NEW LRA POPUP MENU SPLITS ONE BEND INTO TWO
The USAF asked us to add a feature that allowed for splitting a very sharp-angled bend into two adjacent half-bends. This is useful for when a very high bend angle throws its intersection point far from the tube and then creates unreliably high swings in the tangent deviation and bender correction data. |
||
Follow these steps to use with Split Bend Measuring1 - Select the bend to split in an LRA grid. |
OTHER CHANGES
|
Other Pages
- See VTube-LASER Addata ZModem Communications Protocol for more information.
- Back to VTube-LASER
- Back to VTube Software Updates (for LASER Mode)
- See also VTube-STEP
- See also VTube-STEP Revisions
- See VTube-LASER Customer Support Page to download the latest version.
- See the tutorial on DCF - Dual Cylinder Fit
- See the tutorial on DCP - Diameter Cut Planes
- See VTube-LASER Cut Planes
- See How to Measure Tubes Attached to an Evaporator with the DCP Feature