Difference between revisions of "CNC Bender v12-20100316"
From ATTWiki
| Line 30: | Line 30: | ||
<td width=300> | <td width=300> | ||
This new bend option allows you to fine-tune the calculated feed speed during Feed Bending. | This new bend option allows you to fine-tune the calculated feed speed during Feed Bending. | ||
| + | <br><br> | ||
| + | |||
| + | *The value is entered as a percentage. | ||
| + | *The value can be positive or negative floating point number. | ||
| + | *Negative values slow the calculated speed of the Feed axis. | ||
| + | *A value of +100 would double the speed of the Feed axis during draw bending. | ||
| + | *A value of -100 would set the speed at 0 for the Feed axis during draw bending. | ||
| + | |||
</td> | </td> | ||
<td> | <td> | ||
| Line 39: | Line 47: | ||
<tr valign=top> | <tr valign=top> | ||
<td width=300> | <td width=300> | ||
| − | + | For example "-10" means negative 10 percent. | |
</td> | </td> | ||
Revision as of 12:53, 16 March 2010
|
|
|
Contents |
NEW - Feed Speed Percentage Adjustment for Feed Bend Mode
|
This new bend option allows you to fine-tune the calculated feed speed during Feed Bending.
|
|
|
For example "-10" means negative 10 percent. |
Speed calculated at 100% (see vel0) |
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands
