Revision as of 01:39, 13 June 2009

@@ Line 7: / Line 7: @@
 ===[[image:Check.jpg|25px]] NEW - Seam Detect Mode in PreBend Dynamic Options===
-[[image:Seamdetect_application.jpg|300px]]
+<table>
-[[image:Seamdetect_diagram.jpg|300px|right]]
+<tr>
+<td>[[image:Seamdetect_application.jpg|300px]]</td>
+<td>[[image:Seamdetect_diagram.jpg|300px|right]]</td>
+</tr>
+</table>
 The '''seam detect logic''' was ported into the latest version of CNC Bender from the older LiteControl platform.  It uses a secondary process list that runs in parallel to the main process list in order to detect a seam.<br><br>
-The diagram on the right shows the main process in the orange box on the left.  This is the actual bend program process.
-<br><br>
-The box on the right is the secondary process called SEAM_DETECT_ROTATE_AXIS.  It causes the rotate axes to spin until the seam is located and the seam detect input is ACTIVE.  (This process can be modified for your application.)
-<br><br>
-When the seam is detected, then the SEAM_DETECT_ROTATE_AXIS process STOPS RUNNING, causing the ROTATION JOG to also STOP.
-<br><br>
-Then the main process detects that the seam detect input is ACTIVE and  moves to the next step (See "3" in the orange box).<br>
 See [[CNC Bender Seam Detection]] for details.

Difference between revisions of "CNC Bender v11-20090609"