Difference between revisions of "Benderlink for Pines"
From ATTWiki
(→Version 1.0 (Obsolete)) |
|||
| Line 44: | Line 44: | ||
|} | |} | ||
| + | |||
| + | |||
| + | <table cellpadding=10> | ||
| + | <tr> | ||
| + | <td bgcolor="#abbad1">Screen Shot</td> | ||
| + | <td bgcolor="#e3e4f5" width="100">Date Released</td> | ||
| + | <td bgcolor="#abbad1" width="100">Link to Page</td> | ||
| + | <td bgcolor="#e3e4f5">New Features</td> | ||
| + | </tr> | ||
| + | |||
| + | <tr> | ||
| + | <td>[[image:Blinksw_v2_sw180.jpg|100px]]</td> | ||
| + | <td>April 28, 2008</td> | ||
| + | <td>[[Benderlink for Pines 2.0]]</td> | ||
| + | <td> | ||
| + | *100% Compatible with standard Eaton Leonard protocols | ||
| + | *100% Compatible with PINES TS-2000 control | ||
| + | *New Updated User Interface | ||
| + | *New Utilities for working with Benderlink Ethernet Modules - like Ping checking before opening a virtual COM port. | ||
| + | </td> | ||
| + | </tr> | ||
| + | |||
| + | |||
| + | </table> | ||
Revision as of 01:22, 1 May 2008
Contents |
About
| Benderlink for Pines is software that connects PINES TS-2000 controls with Eaton Leonard Vector Laservision measuring centers. It essentially makes a TS-2000 control appear to be an Eaton Leonard PREMIER control to a Vector Laservision measuring center. |
|
TS-2000 Control to Vector 1 Laservision
|
The software installs directly on the operator station of the Pines TS-2000 controls. It is designed to interact directly with the control. The designer of the TS-2000 included a "Laservision" button that loads and calls to Benderlink for Pines. The protocol used is the Velog/El-2000/Premier protocol - so the software is compatible with Eaton Leonard Vector Laservision out of the box. |
|
Version 2.0 - Plug-And-Play Compatible with Vector Laservision
| Version 2 is designed to communicate using the standard Eaton Leonard Velog, EL-2000, and Premier protocol. This protocol is available on every Eaton Leonard measuring center.
|
|
Version 1.0 (Obsolete)
| Version 1 of Benderlink for Pines communicated with Laservisions using the ATT protocol. The ATT protocol was a special protocol that required customers to purchase and install an upgrade to the Vector Laservision. Eaton Leonard referred to this as a "Competitive Bender Interface" because it was designed to grant competitors the right to use the measuring center through license charges.
|
|
| Screen Shot | Date Released | Link to Page | New Features |
 |
April 28, 2008 | Benderlink for Pines 2.0 |
|
Other Pages
Back to the Benderlink Page
