Difference between revisions of "Building Tube Assemblies in SOLIDWORKS"
(→STEP 5: Start a New Assembly) |
(→STEP 6: Create a Reference Plane at the Origin) |
||
Line 41: | Line 41: | ||
− | ==STEP 6: | + | ==STEP 6: Cancel the New Assembly Feature== |
In order to insert the tubes in the proper location, we need to establish the common origin in a plane. So press Cancel new assembly first.<br><br> | In order to insert the tubes in the proper location, we need to establish the common origin in a plane. So press Cancel new assembly first.<br><br> | ||
[[image:vtube-laser_v2.5_solidworks cancel new assembly.png|500px]] | [[image:vtube-laser_v2.5_solidworks cancel new assembly.png|500px]] | ||
+ | |||
+ | |||
+ | ==STEP 7: Create a Reference Plane at the Origin== | ||
+ | Insert a new plane, then press Finish. It is not necessary to change the location of the plane - since it is already centered around the world origin.<br><br> | ||
+ | [[image:vtube-laser_v2.5_solidworks insert a plane.png|500px]] | ||
==Read More About Tube Elongation== | ==Read More About Tube Elongation== |
Revision as of 19:45, 2 June 2016
|
VTube-LASER can reverse engineer tube and then build that tube in SOLIDWORKS as a fully-constrained 3D parametric model. This page describes the basic steps to create an assembly from a part using VTube-LASER and SOLIDWORKS.
STEP 1: Measure One of the Parts in VTube-LASER
Measure the first pipe and create a measured tube shape.
STEP 2: Build the Part in SOLIDWORKS
Use the File tab in Measure Tube Data to send the measured part to SOLIDWORKS.
STEP 3: Save the SOLIDWORKS Part File
Save the part to a unique SOLIDWORKS part file on the disk.
STEP 4: Repeat Steps 1 through 3 for all the parts
Be careful to not move the assembly. Repeat the first three steps for each tube.
STEP 5: Start a New Assembly
Start a new assembly. These steps show how to insert four parts from the SOLIDWORKS part files.
STEP 6: Cancel the New Assembly Feature
In order to insert the tubes in the proper location, we need to establish the common origin in a plane. So press Cancel new assembly first.
STEP 7: Create a Reference Plane at the Origin
Insert a new plane, then press Finish. It is not necessary to change the location of the plane - since it is already centered around the world origin.
Read More About Tube Elongation
Other Pages
- Back to the VTube-STEP page
- Back to the VTube-LASER page