Difference between revisions of "CNC Bender v12-20100324"
From ATTWiki
| Line 32: | Line 32: | ||
<br><br> | <br><br> | ||
The Machine Lube feature shares the Constant Run List timer. This error was only encountered recently because we have begun running CNC Processor loops faster than in previous versions. | The Machine Lube feature shares the Constant Run List timer. This error was only encountered recently because we have begun running CNC Processor loops faster than in previous versions. | ||
| + | </td> | ||
| + | <td> | ||
| + | </td> | ||
| + | </tr> | ||
| + | |||
| + | |||
| + | <tr valign=top> | ||
| + | <td width=300> | ||
| + | </td> | ||
| + | |||
| + | <td> | ||
| + | </td> | ||
| + | </tr> | ||
| + | |||
| + | </table> | ||
| + | |||
| + | <br><br> | ||
| + | |||
| + | |||
| + | ===[[image:Check.jpg|25px]] ADDED - Cycle Hold After Dies Open in Post Bend=== | ||
| + | <table> | ||
| + | <tr valign=top> | ||
| + | <td width=300> | ||
| + | This feature was requested so we added it to CNC Bender.<br><br> | ||
</td> | </td> | ||
<td> | <td> | ||
Revision as of 20:01, 24 March 2010
|
|
|
Contents |
DEBUG - Machine Lube Timer Logic
|
A small bug was removed in the machine lube timer that would prevent the machine lube from starting.
|
|
ADDED - Cycle Hold After Dies Open in Post Bend
|
This feature was requested so we added it to CNC Bender. |
|
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands
