CNC Bender v12-20100324

Type of Upgrade: Minor Upgrade Recovery Rotate Logic Enhancement

ENHANCED- Rotation Recovery Shortest Angle Possible

When a rotation is stopped and recovered by stepping on the safety mat, the rotation direction would not always move the shortest angle and direction to recover. This has been resolved so that all non-linear axes recover in the direction that is measured as the shortest possible angle.

DEBUG - Machine Lube Timer Logic

A small bug was removed in the machine lube timer that would prevent the machine lube from starting. The Machine Lube feature shares the Constant Run List timer. This error was only encountered recently because we have begun running CNC Processor loops faster than in previous versions.

ADDED - Cycle Hold After Last Bend After Dies Open

This feature was requested so we added it to CNC Bender. Now the bender will go into cycle hold after the last bend after the dies open if this option is switched ON in the last bend cell (part release) section.

Other Pages

• Back to CNC Bender
• Back to CNC Bender Software Updates
• See CNC Bender General Information
• See Teach Mode
• See Custom Commands