Difference between revisions of "VTube-LASER v2.9.3"

From ATTWiki
Jump to: navigation, search
(25pxNEW - Support for MicroScribe Arms from Revware)
(25pxNEW - Support for MicroScribe Arms from Revware)
Line 29: Line 29:
  
 
<td width=300>
 
<td width=300>
VTube-LASER now supports the MicroScribe arms using ball probes. These arms are smaller and have fewer axes than regular laser scanning arms from HEXAGON or FARO, and are therefore less expensive than larger arm solutions.
+
VTube-LASER now supports the MicroScribe arms using ball probes.<br><br>
 +
These arms are smaller and have fewer axes than regular laser scanning arms from HEXAGON or FARO, and are therefore less expensive. A VTube-LASER + MicroScribe Arm system costs only $21000 ($26000 with on-site training).
 
<br><br>
 
<br><br>
 
The arm that we developed the link with is a MicroScribe i arm (shown on the right). You can view a PDF brochure here:  
 
The arm that we developed the link with is a MicroScribe i arm (shown on the right). You can view a PDF brochure here:  

Revision as of 20:35, 2 January 2018

Vtube-laser logo 1.96.png


Revision 2.9.3

Release Date: January 10, 2017


Vtube-laser v2.7 screenshot.png


Check.jpgNEW - Support for MicroScribe Arms from Revware

VTube-LASER now supports the MicroScribe arms using ball probes.

These arms are smaller and have fewer axes than regular laser scanning arms from HEXAGON or FARO, and are therefore less expensive. A VTube-LASER + MicroScribe Arm system costs only $21000 ($26000 with on-site training).

The arm that we developed the link with is a MicroScribe i arm (shown on the right). You can view a PDF brochure here: MicroScribe i Brochure

This arm has a two-foot reach (four-foot total volume) with an accuracy of +/- 0.005" (127 microns).

Revware has arms that are accurate to +/-0.002" (51 microns). They also sell a slightly longer arm with higher accuracy than the "i" arm shown here.

Vtl screen with microscribe arm.png



Check.jpgNEW - DENGLER Bender Corrections Support

Dengler benders are known for bending long brake and fuel lines.

This new communications protocol quickly adjusts the DENGLER MES bender files directly that can then be loaded into the DENGLER controls.

Dengler.png

Dengler in bender setup.png



Check.jpgNEW - Guide Windows in Bender Setup

We've put Guide Windows in the Bender Setup menu. They can stay open for as long you as you want - or close them anytime. They are less obtrusive than the dialogs that required the operator to press "OK" to continue.

Vtl 2.9.3 bender setup guide windows.png



Check.jpgOther



Other Pages