Difference between revisions of "VTube-LASER v2.9.3"
(→25pxNEW - Support for MicroScribe Arms from Revware) |
(→25pxNEW - Support for MicroScribe Arms from Revware) |
||
Line 36: | Line 36: | ||
This arm has a two-foot reach (four-foot total volume) with an accuracy of +/- 0.005" (127 microns). | This arm has a two-foot reach (four-foot total volume) with an accuracy of +/- 0.005" (127 microns). | ||
<br><br> | <br><br> | ||
− | Revware has arms that are accurate to +/-0.002" (51 microns). They also sell a slightly longer arm with higher accuracy. | + | Revware has arms that are accurate to +/-0.002" (51 microns). They also sell a slightly longer arm with higher accuracy than the "i" arm shown here. |
</td> | </td> | ||
Revision as of 20:31, 2 January 2018
Revision 2.9.3Release Date: January 10, 2017
|
NEW - Support for MicroScribe Arms from Revware
VTube-LASER now supports the MicroScribe arms with the ball probes. These arms measure smaller parts and are therefore less expensive than larger arm solutions.
|
NEW - DENGLER Bender Corrections Support
Dengler benders are known for bending long brake and fuel lines. |
NEW - Guide Windows in Bender Setup
We've put Guide Windows in the Bender Setup menu. They can stay open for as long you as you want - or close them anytime. They are less obtrusive than the dialogs that required the operator to press "OK" to continue. |
Other
Other Pages
- See VTube-LASER Addata ZModem Communications Protocol for more information.
- Back to VTube-LASER
- Back to VTube Software Updates (for LASER Mode)
- See also VTube-STEP
- See also VTube-STEP Revisions
- See VTube-LASER Customer Support Page to download the latest version.
- See the tutorial on DCF - Dual Cylinder Fit
- See the tutorial on DCP - Diameter Cut Planes
- See VTube-LASER Cut Planes
- See How to Measure Tubes Attached to an Evaporator with the DCP Feature