Difference between revisions of "Reverse the Tube Ends"

From ATTWiki
Jump to: navigation, search
(Reverse the Tube Ends)
(Reverse the Tube Ends)
Line 23: Line 23:
 
<tr valign=top>
 
<tr valign=top>
 
<td width=300>
 
<td width=300>
It is often necessary to reverse the tube ends in order to bend the part from the other end of the tube.  To reverse the tube ends, you can right click on the XYZ grids for the MASTER or MEASURED data and click on '''Reverse the Tube Ends'''.
+
It is often necessary to reverse the tube ends in order to bend the part from the other end of the tube.  To reverse the tube ends, you can right click on the XYZ grids for the MASTER or MEASURED data and click on '''Reverse XYZ Data'''.
 
</td>
 
</td>
 
<td>
 
<td>

Revision as of 15:28, 13 April 2016

Vtube-step logo 1.96.png Vtube-laser logo 1.96.png

VTS2 SplashScreen.png
Vtl screen hd scanner without logo.png



Reverse the Tube Ends

It is often necessary to reverse the tube ends in order to bend the part from the other end of the tube. To reverse the tube ends, you can right click on the XYZ grids for the MASTER or MEASURED data and click on Reverse XYZ Data.

Vtube-laser v2.5 reverse tubeends.png


About Supravision Files

Supravision files usually have a filename extension of $$$.

They are text files that contain part setup, XYZ, and LRA data usually.

They were used by Supravision software to save and load Supravision project files - so they contain a lot of data that VTube understands.

(Supravision software was retired a few years ago by ROMER. It was one of the standards in the industry for decades.)

Svwin.png


Other Pages