Difference between revisions of "CNC Bender v12.8"

From ATTWiki
Jump to: navigation, search
(25px FIXED: Teach Mode and Custom Commands Issue Solved)
(25px FIXED: Teach Mode and Custom Commands Issue Solved)
Line 22: Line 22:
 
<td width=600>
 
<td width=600>
  
<h4><b>Note: This fix applies only to bender with non-standard axis numbering for the Feed or Rotate axes (that does not match Feed = 1, Rotate = 2)</b></h4>
+
<h4><b>This fix only applies to bender with non-standard axis numbering for the Feed or Rotate axes (that does not match Feed = 1, Rotate = 2).  For example, if you have a hybrid hand-bender with CNC Bender and you use custom commands for the ROTATE axis, then this upgrade is important to you.</b></h4>
  
 
Custom commands can be entered after every bend in the FRB page.  SMT discovered a that FEED and ROTATE commands would not be completed properly when coming out of a custom move.<br><br>
 
Custom commands can be entered after every bend in the FRB page.  SMT discovered a that FEED and ROTATE commands would not be completed properly when coming out of a custom move.<br><br>

Revision as of 15:11, 28 February 2014

v12.8 - February 1, 2014

Cncv12procontrol withteachmode.jpg


Check.jpg FIXED: Teach Mode and Custom Commands Issue Solved

This fix only applies to bender with non-standard axis numbering for the Feed or Rotate axes (that does not match Feed = 1, Rotate = 2). For example, if you have a hybrid hand-bender with CNC Bender and you use custom commands for the ROTATE axis, then this upgrade is important to you.

Custom commands can be entered after every bend in the FRB page. SMT discovered a that FEED and ROTATE commands would not be completed properly when coming out of a custom move.

  • For example, the ROTATE was programmed at 90 degrees. The custom move is 89 degrees - so the finish up command should be set to 1 degree to come to the full 90. However, the finish-up command was 90 degrees - which caused the rotate to move to 89 + 90 = 179 degrees.

  • This problem occurred on benders where the ROTATE axis is set to a non-standard machine axis 3 because the machine axis number was hard coded into the process list builder.

  • Process list builder now has logic that anticipates that the machine axis number for any motion actuator can change depending on the application.


Check.jpg ENHANCED: Load and Start Positions with Bend Arm Motion Option (in Pre Bend)

The Option List panels now clear if all options are placed in the tool box.

Cncbender OptionPanelCleared.png



Check.jpg Other Changes

  • New version number set in all executables: 12.8




Other Pages