Difference between revisions of "End-Scan Using the Scissor Motion"
From ATTWiki
(→How To Use This End-Scan Technique) |
(→How To Use This End-Scan Technique) |
||
Line 55: | Line 55: | ||
* Align the scanner with a slight scissor angle across the end as is shown in the image on the right<br><br> | * Align the scanner with a slight scissor angle across the end as is shown in the image on the right<br><br> | ||
* Attempt to hold the laser motionless when collecting the stripes across the end to increase repeatability.<br><br> | * Attempt to hold the laser motionless when collecting the stripes across the end to increase repeatability.<br><br> | ||
− | * Consistently place the line across the same area of the | + | * Consistently place the line across the same area of the tube end from measure to measure.<br><br> |
*Press the green button until VTube-LASER is finished scanning all the end stripes.<br><br> | *Press the green button until VTube-LASER is finished scanning all the end stripes.<br><br> | ||
[[image:EndWithScissorCloseup.jpg|300px]]<br><br> | [[image:EndWithScissorCloseup.jpg|300px]]<br><br> |
Revision as of 03:44, 1 February 2012
How to perform quick scissor motion end-scans.
|
Why the End-Scan technique is important
This end-scan method is useful for ease-of-use and quickness.
|
Measure Setup
|
How To Use This End-Scan Technique
|
Other Pages
- See also End-Scan Using the End Wall
- See also End-Scan Using End Targets
- Back to VTube-LASER