Difference between revisions of "CNC Bender v11-20090729"
From ATTWiki
| Line 26: | Line 26: | ||
<tr> | <tr> | ||
<td width="200"> | <td width="200"> | ||
| − | The new Kicker option allows for easy setup of a kicker actuator that kicks the part off the bender at the end of the bend cycle. | + | The new Kicker option allows for easy setup of a kicker actuator that kicks the part off the bender at the end of the bend cycle.<br><br> |
| + | *Set the Kicker COMDEF names in Low Level<br><br> | ||
| + | *Enable the Kicker in the PostBend section of Bender Data. | ||
</td> | </td> | ||
<td> | <td> | ||
| − | [[image:cncbender_kicker_lowlevel.jpg| | + | [[image:cncbender_kicker_lowlevel.jpg|500px]]<br><br> |
| − | [[image:cncbender_kicker_postbend.jpg| | + | [[image:cncbender_kicker_postbend.jpg|500px]]<br><br> |
</td> | </td> | ||
</tr> | </tr> | ||
</table> | </table> | ||
| − | |||
| − | |||
===[[image:Check.jpg|25px]] ENHANCED - Option Speed Edit Button === | ===[[image:Check.jpg|25px]] ENHANCED - Option Speed Edit Button === | ||
Revision as of 20:04, 19 August 2009
REDESIGN - Hopper and Side Loaders Setup Simplified
|
|
NEW - Kicker Option in Low Level and PostBend
|
The new Kicker option allows for easy setup of a kicker actuator that kicks the part off the bender at the end of the bend cycle.
|
|
ENHANCED - Option Speed Edit Button
|
The option speed edit button now defaults to the UP (off) position whenever an option list loads to the screen. |
|
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- Read about Push Bending
- Read about Push Bend Profile Tables
