How to Switch the OD Mesh On/Off

From ATTWiki
Revision as of 14:49, 8 September 2012 by Mcone (Talk | contribs)

Jump to: navigation, search

Tcadpro logo.jpg

Contents


Entities Described

The OD Mesh can be composed of two types of entities - either WIRE or SURFACE. Either can be switched on or off independently in TubeCAD. This page describes ways to control them.

Switch Straights Wire

Switch the straights WIRE mesh off in the straights by using the Primary Views>3D>Straights wire>On/Off

Tcadpro 3d straightwires off.jpg


Switch Arcs Wire

Switch the arcs WIRE mesh off in the straights by using the Primary Views>3D>Arcs wire>On/Off

Tcadpro 3d arcwires off.jpg

Switch Straights Faces

Switch the straights surface mesh off in the straights by using the Primary Views>3D>Straights faces>On/Off

Tcadpro 3d straightfaces off.jpg

Tcadpro 3d straightfaces off2.jpg

Switch Arcs Wire

Switch the arcs surface mesh off in the straights by using the Primary Views>3D>Arcs faces>On/Off

Tcadpro 3d arcfaces off.jpg

Tcadpro 3d arcfaces off2.jpg

Switch Between Surface and Outline Quickly

You can switch between surface and outline display quickly by pressing on the right toolbar button with the surface mesh.

Tcadpro surface outline switch button.jpg

Step 3: Start the DXF File Import Feature

In the File pulldown menu, select the Import - DXF File command. Select the DXF file to import then press OK.

  • Select DXF file.
  • Select the centerline layer name and the centerline arc layer name
  • Press "Load File"

Tcadpro dxfimport3.jpg



Step 4: Organize the Layout

The display will change. It may look something like this. If you see nothing, then press the Zoom Extents feature.

  • Type the word "auto" in the command line and press the Enter key.
  • Enter "4" and press Enter. This selects the most comprehensive formatting available for TubeCAD Pro layouts.
  • The layout will reorganize itself like this:

Tcadpro dxfimport4.jpg

Tcadpro dxfimport5.jpg

Step 5: Set the Diameter

The incoming data will not contain a diameter, so you can set that value in the General Spec menu.

  • Either press the GS button or type "spec" and press Enter.
  • Enter the diameter in the Outer Diameter field
  • Press the "Reset View Diameters" button.
  • Press the OK button at the bottom of the window

Tcadpro dxfimport6.jpg

The image will display something like this:

Tcadpro dxfimport7.jpg

Step 6: Zoom Extents

Zoom to the extents to see the entire layout.

This entire process takes just a few minutes.

Tcadpro dxfimport8.jpg

Other Pages

Go back to TubeCAD Pro