Difference between revisions of "20191206 FARO Arm - Movement Filter set to zero"
From ATTWiki
(Created page with " Back to VTube-LASER ==CUSTOMER ARM MODEL== *FARO Arm *Edge *BluLaser Scanner ==CUSTOMER ISSUE== The customer could not get any laser data into VTube-LASER. ==OUR DISCO...") |
(→OUR DISCOVERY) |
||
| Line 13: | Line 13: | ||
The FARO driver has a new Movement Filter option that has an impact on scanning whether or not is enabled. | The FARO driver has a new Movement Filter option that has an impact on scanning whether or not is enabled. | ||
| − | [[image:FARO_MFilter_001.png| | + | [[image:FARO_MFilter_001.png|700px]] |
==OTHER ACTIONS== | ==OTHER ACTIONS== | ||
Revision as of 17:05, 6 December 2019
Back to VTube-LASER
Contents |
CUSTOMER ARM MODEL
- FARO Arm
- Edge
- BluLaser Scanner
CUSTOMER ISSUE
The customer could not get any laser data into VTube-LASER.
OUR DISCOVERY
The FARO driver has a new Movement Filter option that has an impact on scanning whether or not is enabled.
OTHER ACTIONS
The customer calibrated the ball probe (it passed spec) and then calibrated the laser probe. It did not pass spec. However, it did calibrate to 0.0675 mm (0.0027") - which is very good for tube fabrication. The customer saved the calibration results anyway and continued.
Since the probes were recalibrated, it was also necessary to re-establish the CUT PLANE.
RESULT
VTube-LASER now scans the 5 mm wire with no problems.
