VTube-STEP v1.77.4

From ATTWiki
Revision as of 20:43, 8 August 2012 by Mcone (Talk | contribs)

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

Vtube-step logo.jpg

Revision 1.77.4

Vtube-step 1.77.3a.jpg



Check.jpg ENHANCED: Allow the Drawing of ZERO Value Radii

Vtube 1.77.4 zerovalueradius.jpg

VTube can now draw a zero-radius bend in the model with displaying an error.

Check.jpg NEW: Diameter Model End Lengths Change Based on New "End Adjustment Length" Values in Part Setup

Vtube 1.77.3 EndLengthShortened Closeup.jpg

When the A-End or B-End Adjustment Lengths change, then the diameter model lengths change automatically at the next redraw. This does not change the centerline end point location.

Vtube 1.77.3 EndLengthShortened.jpg

Check.jpg REPAIR: The Cut Length Calculation with Non Zero End Adjustments Is Repaired

Vtube endlength cutlength partsetup.jpg

The End Length Adjustments values are no longer doubled in the Cut Length calculation.

Other Pages

Retrieved from "http://www.advancedtubular.wiki/index.php?title=VTube-STEP_v1.77.4&oldid=19048"