VTube-LASER v2.9.5

Revision 2.9.5 Release Date: February 19, 2018 Build: Back to VTube-LASER Back to VTube-LASER Updates See also VTube-STEP Updates Download updates the Support Page

ENHANCED - FASTER USER INTERFACE

VTube is now faster due to some important changes to the user interface.

FIX - SOLID MODEL IMAGE PRINT IN REPORTS

VTube is designed to handle multiple displays. We discovered that, for windows arrangements where the Windows Desktop is not on the far left monitor, VTube might not print the graphics image properly in reports. This has been fixed in this version.

NEW - SEPARATE PERSPECTIVE MODES FOR STEP and LASER WINDOWS

In previous versions, there was only a single Perspective Mode switch. In this version, there is a separate Perspective Mode switch for STEP and LASER windows.

NEW - REQUEST REVERSE CALC WHEN EXITING THE LRA GRIDS

When you edit the data in the LRA grid, VTube-LASER now assumes that you probably mean to perform a reverse calc. If you exit the grid without a reverse calc, then it will immediately ask if you intended to perform a Reverse Calc - and allow you to choose to calculate the XYZ data. This is active in both the MASTER and the MEASURED LRA grids.

FIX - REPAIRED LOSS OF ORIGINAL ORIENTATION DURING REVERSE CALC

VTube always attempts to keep the original XYZ orientation when you perform a Reverse Calc from LRA to centerline XYZ data. We discovered that certain situations would cause VTube to lose the orientation during Reverse Calc. This has been fixed in this version.

FIX - BUILD TO SOLIDWORKS ASSEMBLY

VTube would incorrectly build single tubes to a SOLIDWORKS assembly. This has been changed so that single tubes are always built to single SOLIDWORKS part drawings.

Other Pages

• See VTube-LASER Addata ZModem Communications Protocol for more information.
• Back to VTube-LASER
• Back to VTube Software Updates (for LASER Mode)
• See also VTube-STEP
• See also VTube-STEP Revisions
• See VTube-LASER Customer Support Page to download the latest version.
• See the tutorial on DCF - Dual Cylinder Fit
• See the tutorial on DCP - Diameter Cut Planes
• See VTube-LASER Cut Planes
• See How to Measure Tubes Attached to an Evaporator with the DCP Feature