Difference between revisions of "VTube-LASER v2.9.11"
(→25pxNEW - STAR TECNOLOGY Bender Corrections Through a Network (VTube-LASER Only)) |
(→25pxNEW - HERBER Bender Setup From Solid Model Through a Network (VTube-LASER or VTube-STEP)) |
||
| Line 92: | Line 92: | ||
[[image:vtl_v2.9.11_bendersetup_STAR_EVO.png|700px]] | [[image:vtl_v2.9.11_bendersetup_STAR_EVO.png|700px]] | ||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
</td> | </td> | ||
</tr> | </tr> | ||
Revision as of 20:23, 22 July 2018
|
Revision 2.9.11Release Date: July 20, 2018
|
|
NEW LASER SCAN LOGIC FOR RECTANGULAR AND SQUARE TUBES
|
IF YOU MEASURE SQUARE TUBES WITH THE LASER SCANNER, THEN THIS IS AN IMPORTANT UPDATE FOR YOU. The rectangular and square LASER scanning logic is much improved over the previous version. If you can square or rectangular tubes, then this version is especially important for you. |
|
NEW - RECTANGULAR PROBE OFFSET DIRECTION LOGIC CORRECTED
|
IF YOU MEASURE SQUARE TUBES WITH THE BALL PROBE, THEN THIS IS AN IMPORTANT UPDATE FOR YOU. We discovered that the rectangular and square tube measurements might project the planes to the wrong side of the ball probe. This incorrect compensation would cause the centerline to shift by up to double the ball diameter. This has been fixed in this version. |
|
NEW - STAR TECNOLOGY Bender Corrections Through a Network (VTube-LASER Only)
|
We added the STAR EVO SVNet file correction support that allows VTube-LASER to correct STAR EVO benders through a network connection automatically.
Bender corrections only work through VTube-LASER. (Not VTube-STEP) |
|
NEW - VTUBE-LASER TUNED TO WORK WITH THE NEW FARO 6.1.2.7 USB DRIVER
|
FARO USB driver 6.1.2.7 is a rewrite of the USB driver. It has many improvements that are very much worthwhile - like the scanner calibration is much improved.
|
|
OTHER CHANGES
Other Pages
- See VTube-LASER Addata ZModem Communications Protocol for more information.
- Back to VTube-LASER
- Back to VTube Software Updates (for LASER Mode)
- See also VTube-STEP
- See also VTube-STEP Revisions
- See VTube-LASER Customer Support Page to download the latest version.
- See the tutorial on DCF - Dual Cylinder Fit
- See the tutorial on DCP - Diameter Cut Planes
- See VTube-LASER Cut Planes
- See How to Measure Tubes Attached to an Evaporator with the DCP Feature
