VTube-LASER v1.86

Revision 1.86 Back to VTube-STEP Back to VTube-STEP Revisions Back to VTube Software Updates (for LASER Mode) Back to VTube-LASER

• See VTube-LASER Customer Support Page to download the latest version.

ENHANCED: Bender Number Stored in Project

The bender number selected for communications is now stored in the project file for recall later. This is because the same bender is referenced often for a given part.

ENHANCED: AddisonMckee Mark IV EXTENDED Communications

Some AddisonMckee Mark IV benders require that all the teach mode data be returned during an automated bender correction. VTube-LASER now handles this data if it is available during a RECALL options from the bender. If the Mark IV data is available, then a new tab menu appears next to the correction grid in Bender Data Setup. This tab menu shows the AddisonMckee custom data. It can be read but not modified. Be sure to perform a RECALL from the AddisonMckee before attempting to SEND corrections. This will ensure that this data is stored and returned to the bender at correction time.

Other Changes

Changes were made to the interface to clear up the potential for orphaned windows in the Dell M6700 laptops. For example, when the LASER mode window is displayed, then the STEP mode window disappears. VTube-LASER is quicker to return a message when it any network connection no longer exists.

Other

• Back to VTube-STEP
• Back to VTube Software Updates (for LASER Mode)
• Back to VTube-LASER
• See VTube Language Editor