VTube-LASER v1.73

From ATTWiki
Revision as of 23:38, 20 October 2011 by Mcone (Talk | contribs)

Jump to: navigation, search

Vtube-laser logo.jpg

Revision 1.73

Back to VTube-LASER
Back to VTube-STEP

Vtube-laser 1 73.jpg

Contents


Check.jpg ENHANCED: Fine Tune for FARO Edge ScanArm

The FARO Edge uses a different scan rate than the older arms. VTube-LASER was adjusted to work with the FARO Edge arms.

Check.jpg ENHANCED: Cut Plane Offset Reset

The Cut Plane Offset can now be changed without remeasuring the Cut Plane.

Vtube-laser cutplaneoffset changeoffet v1 73.jpg

Check.jpg ENHANCED: Cut Plane Offset Value

The Cut Plane Offset Value is now displayed above the Cut Plane icon.

Vtube-laser cutplaneoffset displayoffet v1 73.jpg

Check.jpg NEW: Split Bend Model Display

New Split Bend model geometry is included on the screen when measuring split bends in order to visually verify the calculations.

Vtube-laser splitbend model geometry.jpg

Check.jpg NEW: XYZ INTERSECTION STRAIGHT LENGTHS

A new chart is included in the inspection report that shows the lengths between intersections for both the MASTER and MEASURED as well as the Delta between the two.

Vtube-laser intersection staight length report.jpg

Check.jpg Other Changes

  • A graphics model memory leak was repaired where project files continued to grow in size every save and load. This change makes loading and saving much faster in VTube.

  • The Split Bend logic was enhanced and Split Bend envelopes were enhanced.

  • New confirmation menus for when pressing STOP or CLEAR the measure process. This prevents accidentally canceling measuring processes.

Check.jpg Issues with this version fixed in newer versions

  • No known issues



Other Pages

VTube-LASER Training Video - How to perform effective end scans.

Vtube-laser effective end scan video b.jpg