Difference between revisions of "VTube-LASER v1.73"
From ATTWiki
| Line 27: | Line 27: | ||
</table> | </table> | ||
| − | ===[[image:Check.jpg|25px]] ENHANCED: Cut Plane Offset=== | + | ===[[image:Check.jpg|25px]] ENHANCED: Cut Plane Offset Reset=== |
<table cellpadding=10> | <table cellpadding=10> | ||
| Line 40: | Line 40: | ||
</tr> | </tr> | ||
</table> | </table> | ||
| − | |||
===[[image:Check.jpg|25px]] ENHANCED: Cut Plane Offset Value=== | ===[[image:Check.jpg|25px]] ENHANCED: Cut Plane Offset Value=== | ||
Revision as of 21:12, 20 October 2011
|
Revision 1.73Back to VTube-LASER |
|
Contents |
ENHANCED: Fine Tune for FARO Edge
|
The FARO Edge uses a different scan rate than the older arms. VTube-LASER was adjusted to work with the FARO Edge arms. |
ENHANCED: Cut Plane Offset Reset
|
The Cut Plane Offset can now be changed without remeasuring the Cut Plane.
|
|
ENHANCED: Cut Plane Offset Value
|
The Cut Plane Offset Value is now displayed above the Cut Plane icon.
|
|
NEW: Split Bend Model Display
|
New Split Bend model geometry is included on the screen when measuring split bends in order to visually verify the calculations. |
|
Other Changes
|
Issues with this version fixed in newer versions
|
Other Pages
- Back to VTube-LASER
|
VTube-LASER Training Video - How to perform effective end scans. |
|
