VTube-LASER v1.63

From ATTWiki
Revision as of 16:13, 1 April 2011 by Mcone (Talk | contribs)

Jump to: navigation, search

Vtube-laser logo.jpg

Revision 1.63

Back to VTube-LASER

Vtube-laser 1 63.jpg



Check.jpg NEW: Select and Configure any number of Reports

The Report menu was redesigned so that operators choose from a list of report templates to show any one of several reports.

  • Edit the list (Add, Delete, Move the template up or down).
  • Edit any template in the included Notepad++ editor (installs with v1.63).
  • Explore the folder that contains the templates.
  • Give the report template a new name.
  • There is no limitation on the number of templates allowed.
  • The report template setup is stored local to the computer (not in project files).

Vtube-laser report templates control.jpg



Check.jpg Other Changes

  • Updated the graphics engine for faster redraws.
  • Added more report values - master length, measured length, delta between measured and master, bender setup LRA

  • Updated the manual and help file.



Check.jpg NEW: Multiple Point Qualification End Scan

VTube-LASER now uses multiple points to qualify the end-scan. This gives it better protection against outlier points.

A new End-Scan Fit window gives information about how many points were used in the end-trim, and the span of all the point positions. Higher point counts with lower spans indicate a better data set for end-trim.

Vtube-laser endscan fitwindow.jpg



Check.jpg REPAIR: Diameter and Wall Detection for STEP Mode

See VTube-STEP v1.62 for details.

Vtube-step 1 62.jpg



Check.jpg Other Changes

  • The A End and B End OFFSETs other than ZERO caused a problem where end-scans would never be qualified. This has been resolved in this version.



Check.jpg Issues with this version fixed in newer versions

  • No known issues

Other Pages

VTube-LASER Training Video - How to perform effective end scans.

Vtube-laser effective end scan video b.jpg