VTube-LASER v1.63

Revision 1.63 Back to VTube-LASER

NEW: Select and Configure any number of Reports

The Report menu was redesigned so that operators choose from a list of report templates to show any one of several reports. Edit the list (Add, Delete, Move the template up or down). Edit any template in the included Notepad++ editor (installs with v1.63). Explore the folder that contains the templates. Give the report template a new name. There is no limitation on the number of templates allowed. The report template setup is stored local to the computer (not in project files).

NEW: Scan Rate Types: Timer or Distance

Now all scan rates are determined by either a TIMER or a DISTANCE. For end-scans, use a timer and set the timer value to 0 milliseconds. For cylinder scans, you can use DISTANCE and set the Cylinder Scan Distance to whatever value is convenient for separation.

NEW: Multiple Point Qualification End Scan

VTube-LASER now uses multiple points to qualify the end-scan. This gives it better protection against outlier points. A new End-Scan Fit window gives information about how many points were used in the end-trim, and the span of all the point positions. Higher point counts with lower spans indicate a better data set for end-trim.

REPAIR: Diameter and Wall Detection for STEP Mode

See VTube-STEP v1.62 for details.

Other Changes

The A End and B End OFFSETs other than ZERO caused a problem where end-scans would never be qualified. This has been resolved in this version.

Issues with this version fixed in newer versions

No known issues

Other Pages

• Back to VTube-LASER

VTube-LASER Training Video - How to perform effective end scans.