Difference between revisions of "VTube-LASER v1.59"

From ATTWiki
Jump to: navigation, search
(25px ENHANCEMENT- Part Name is Used as Filename When Part Name Changes)
(25px REPAIR- Linear Units Set Properly At Load)
Line 67: Line 67:
 
<tr>
 
<tr>
 
<td width=200>
 
<td width=200>
In previous versions, the an Inch part would load and sometimes reset to Millimeters on the screen.
+
In previous versions, an Inch part would sometimes load then reset to Millimeters on the screen.
 
<br><br>
 
<br><br>
 
This has been corrected in this version.</td>
 
This has been corrected in this version.</td>

Revision as of 21:34, 9 February 2011

Vtube-laser logo.jpg

Revision 1.59

Back to VTube-LASER

Vtube-laser 1 57.jpg



Check.jpg NEW: Help Reference for LASER Mode

Now VTube-LASER has its own help reference.

Vtube-laser help button.jpg

Vtube-laser help reference.jpg



Check.jpg REPAIR: Mix ball probe and laser measurement

Using ball probe measurements on the end scans and and laser measurements in the cylinder straights now offsets the ball radius point properly in every case.

Vtube-laser ballprobe endscan.jpg




Check.jpg ENHANCEMENT- Part Name is Used as Filename When Part Name Changes

In previous versions, the part name was used as the filename only if the previous filename was empty.

Now - when the part name changes, the part name is used as the initial filename in the Save dialog.

Vtube savefile partname.jpg




Check.jpg REPAIR- Linear Units Set Properly At Load

In previous versions, an Inch part would sometimes load then reset to Millimeters on the screen.

This has been corrected in this version.

Vtube laser linear units.jpg



Check.jpg Changes to VTube-STEP



Check.jpg Issues with this version fixed in next version

  • No known issues

Other Pages