Difference between revisions of "VTube-LASER v1.59"

From ATTWiki
Jump to: navigation, search
(25px ENHANCEMENT- Part Name is Used as Filename When Part Name Changes)
(25px Changes to VTube-STEP)
Line 65: Line 65:
 
<tr valign=top>
 
<tr valign=top>
 
<td width=500>
 
<td width=500>
* See [[VTube-STEP v1.59]] for changes to the STEP mode.</td>
+
* See [[VTube-STEP v1.59]] for changes to the STEP mode in this version.</td>
 
<td width=300>
 
<td width=300>
 
</td>
 
</td>
 
</tr>
 
</tr>
 
</table>
 
</table>
 
  
 
===[[image:Check.jpg|25px]] Issues with this version fixed in next version===
 
===[[image:Check.jpg|25px]] Issues with this version fixed in next version===

Revision as of 21:23, 9 February 2011

Vtube-laser logo.jpg

Revision 1.59

Back to VTube-LASER

Vtube-laser 1 57.jpg



Check.jpg NEW: Help Reference for LASER Mode

Now VTube-LASER has its own help reference.

Vtube-laser help button.jpg

Vtube-laser help reference.jpg



Check.jpg REPAIR: Mix ball probe and laser measurement

Using ball probe measurements on the end scans and and laser measurements in the cylinder straights now offsets the ball radius point properly in every case.

Vtube-laser ballprobe endscan.jpg




Check.jpg ENHANCEMENT- Part Name is Used as Filename When Part Name Changes

In previous versions, the part name was used as the filename only if the previous filename was empty.

Now - when the part name changes, the part name is used as the initial filename in the Save dialog.

Vtube savefile partname.jpg

Check.jpg Changes to VTube-STEP

Check.jpg Issues with this version fixed in next version

  • No known issues

Other Pages